1150 GSA side stand switch wiring

[Stuart O]

Just fitted a lazer / Remus Y piece ( not sure which ) I have noticed that the Lambda probe cable had to be re-routed and that the side stand switch wiring is v close to hot Y piece - can you see this causing a problem - was planning to wrap the cable in HT webbing type material - is this required..

Thansk in advance....

Stuart

 

[Bigtwin]

Why did you have to re-route the lambda probe? On mine, I just screwed it out of the OE pipe, then back into the Y?

 

[Stuart O]

Why did you have to re-route the lambda probe? On mine, I just screwed it out of the OE pipe, then back into the Y?

wiring was too tight .... had no option

 

[Bigtwin]

wiring was too tight .... had no option

Oh. Well, heat and plastic wiring aren't great mates, so I would definately either lenthten it and get it away from the pipe, or shield it well (difficult) or there will be trouble ahead...