1150GS sump guard bolts

[Fireblade]

Does anyone know the spec of the front sleeve bolts for the lower 1150GS sump guard?
I foolishly wound them back onto the threads so as to not lose them, and then went for a test ride

RealOEM and Motorworks show two spacers that screw onto the mounting bolts. My bike has a different system, the front two spacers are part of the sump guard itself.

 

[albatross]

Have a look…any good ?
Should be an M6….thats from a standard GS with inner and outer tray!
Just seen your set up now…not sure if that isn’t GSA??

 

[Fireblade]

Have a look…any good ?
Should be an M6….thats from a standard GS with inner and outer tray!
Just seen your set up now…not sure if that isn’t GSA??
View attachment 533891View attachment 533889View attachment 533890View attachment 533892

Thanks! Those might just be what I need. I’ve never paid them much attention, I take them off, set them aside, put them back on. It’s not an ADV, but it’s possible a previous owner upgraded some parts.

Now to see where I can find them in Ireland …

 

[Paul Young]

The same part is the core cap nut part of a bmw 530i valve cover fixing. Sytners have them by the looks of it

https://www.sytnerstevenagebmwparts.co.uk/p/Bmw__530i/Cap-nut-M6/131956941/11121738607.html

There are lots of M6 sleeve nuts on eBay for less cost though. Just use Albert’s dimensions and you can’t go wrong.