2008 GS How remove ECU gubbins?

[landmarkjohn]

You may have seen my other thread re EWS issue, anyway I'm getting deep down and dirty with the wiring loom looking for broken wiring.

Tank is off. Now I want to get the ECU holder off the frame to make space to get the loom loosened up around the headstock. I see I have a a round clip type at the bottom both sides of ECU holder and the bottom is loose. I am trying to figure out the top fastening.

Any pointers or links to teardown (as the Yanks would say, great word ) videos appreciated. Or any other words of wisdom on this task. Thanks.

 

[Steptoe]

If you’re struggling and needing to ask how to remove the plastic ECU holder I’d go no further in your attempt to get “deep down and dirty” …

 

[landmarkjohn]

If you’re struggling and needing to ask how to remove the plastic ECU holder I’d go no further in your attempt to get “deep down and dirty” …

Ashure I'll keep tipping away..... any help appreciated.

I replaced the timing belt on my Volvo V70 the other day so I can do a little bit....

 

[landmarkjohn]

It's the fixing circled in red that I'm wondering about. Does it tap through with a drift or unscrew or something. Forgive me but the eyes aren't as good as they used to be and the light and shadows... I could go on

 

[Scotriders]

It's the fixing circled in red that I'm wondering about. Does it tap through with a drift or unscrew or something. Forgive me but the eyes aren't as good as they used to be and the light and shadows... I could go on

It pulls off, just a locating pin sitting in a rubber bush.

Sent from my SM-T580 using Tapatalk

 

[landmarkjohn]

It pulls off, just a locating pin sitting in a rubber bush.

Sent from my SM-T580 using Tapatalk

Perfect, many thanks.