Mark Hooton
Cymarcbikeparts
Height Adjustable Side Stand Foot Plate
A few fellow GS riders asked me if I could come up with a solution to the problem of the bike sitting too far over on the stand.
My solution was to adapt my side stand foot plate and use `packers` underneath to pack up the side stand plate by either 6mm or 12mm depending on if one or both packers were used.
The image show the foot plate with 2 6mm packers giving a 12mm total adjustment. The kit comes with both packers (of course) and 2 sets of different length fasteners.
So, the product offers the following features:
It allows you to adjust the lean of the bike when on the side stand.
It acts as a weight spreader when using the side stand on soft ground.
The packers are made from aluminium with the top and bottom plate being Stainless Steel. The fasteners are coach bolt headed so there is no fastener cavity to wear away on the bottom plate.
It can be fully viewed at www.cymarcbikeparts.co.uk
[/url][/IMG]
A few fellow GS riders asked me if I could come up with a solution to the problem of the bike sitting too far over on the stand.
My solution was to adapt my side stand foot plate and use `packers` underneath to pack up the side stand plate by either 6mm or 12mm depending on if one or both packers were used.
The image show the foot plate with 2 6mm packers giving a 12mm total adjustment. The kit comes with both packers (of course) and 2 sets of different length fasteners.
So, the product offers the following features:
It allows you to adjust the lean of the bike when on the side stand.
It acts as a weight spreader when using the side stand on soft ground.
The packers are made from aluminium with the top and bottom plate being Stainless Steel. The fasteners are coach bolt headed so there is no fastener cavity to wear away on the bottom plate.
It can be fully viewed at www.cymarcbikeparts.co.uk
ordered one of thems i have...cheers
