adjustment

[GS Rider]

Can anyone advise me, on how to adjust the gear foot lever.

As I have fitted migsel lowering peg's, and its a tad to high.

It has one nut but nothing to turn the bolt with, as the brake lever adjustment has.

Bill

 

[Bigtwin]

Wot bike?

I'm guessing it's capative, and you just turn the nut, take out the bolt entirely, move on the spline to desired position, then reverse the procedure?

 

[GS Rider]

Wot bike?

I'm guessing it's capative, and you just turn the nut, take out the bolt entirely, move on the spline to desired position, then reverse the procedure?

Bigtwin
1/ 1150 adventure 2/ How do you remove the spline? as it seem's to have a ball joint at either end!.

 

[DavidHale]

Might be some help on this thread.

 

[GS Rider]

Might be some help on this thread.

Shame about my German,
but it look's like I need to prize the ball joint off?? I think anyway! cheers Dave I go give it a try

 

[GS Rider]

Job done,
Thanks to Dave and Bigtwin for your help, after seeing those photo's, I noticed the small pin clip located around the lower ball joint body, pulling it away and up out of the hole it's located in.
The lower ball joint pull,s neatly away, then just a rotation in the right direction for your foot pref, and re-fit the pin into the hole and re-push back around the ball. JOB DONE