Bearing numbers final drive

[rocky burns]

Has anyone got the bearing numbers and seal numbers handy for the final drive on a 2005 gsa please?
I have a whine on the rear end but no play so going to change the lot as a process of elimination.
I'm assuming they are all the same
Cheers R.B

 

[cookie]

i have the big bearing sat in front of me here. it's a FAG 61917.C3

they're forty quid from motorworks.

the seal's been binned, but they are twenty quid from mw.

 

[rocky burns]

Cheers Cookie
How about the input bearing on the shaft.
Do these go? as may as well change this at the same time if they do??

R.B

 

[cookie]

i left it well alone.

special tool required to undo it i think.

 

[rocky burns]

i left it well alone.

special tool required to undo it i think.

Ok.
I can see if its noisy once the rest is stripped down, i'll change it then if it is.
Thanks

 

[Pekkavee]

i have the big bearing sat in front of me here. it's a FAG 61917.C3
they're forty quid from motorworks.
the seal's been binned, but they are twenty quid from mw.

FAG 61917.C3 is for R1100 and R1150 bikes and many others, but not for R1200GSA.

Pekka