CandyMan_ZA
Registered user
I sorted the squeel on mine by removing the pads, cleaning them as well as the spring and bolt as well as the caliper housing with a brush and petrol, used a grinder and lightly took the sharp edge off the pads, smoothed the whole lot down, surface included, with medium sand paper, lightly copper greased the back of the pads and bolt and spring, re-assembled and bingo, no more squeel, a 5 minute job. 
Kevin
R1200GS-WP
ps. take note of where the securing clip goes because if you put it back in the wrong place and you loose the bolt, especially now that it is greased you gonna lose a pad, or worse!
Kevin
R1200GS-WP
ps. take note of where the securing clip goes because if you put it back in the wrong place and you loose the bolt, especially now that it is greased you gonna lose a pad, or worse!
