Brake failure warning
- Thread starter Swansea Jack
- Start date
Get that often on my GSA usually goes off after a while riding.
Sent from my FIG-LX1 using Tapatalk
Year off Bike would help But I suspect a Post 2006 with the later NON servo ABS
It usually means that your brushes are stuck and not contacting the motor windings
If it is a Non whizzy brake model it is safe enough to ride as they did away with the 4 brake circuit system of the servo brakes
It usually means that your brushes are stuck and not contacting the motor windings
If it is a Non whizzy brake model it is safe enough to ride as they did away with the 4 brake circuit system of the servo brakes
2005 servo braked model
Servoectomy & 30 mins to adjust the kombi
bout £50 in parts maxor you can spunk £1200 at the dealer for a new unit
first quote sounds a lot better SantaServoectomy & 30 mins to adjust the kombi
or you can spunk £1200 at the dealer for a new unit
If you do a search here you will find shed loads of info on this as it's been done to death 
Thank you will doIf you do a search here you will find shed loads of info on this as it's been done to death
Did the brakes become crap ??
If not it May be fluid levels or a dodgey rear lamp assembly You should have a flash code sticker under the saddle to tell you what the failure is if the lights are flashing a code
If you need it This is the thread https://www.ukgser.com/forums/showt...-COST-servo-removal-of-1150-IABS-system/page1
BUT you can skip to post 195 for a much less invasive method for the 1200s
Smiffypr
Registered user
If you can get the OBD fault codes read, you would have a much better idea of what is causing the fault lamp. If the red triangle isn't lit up I would guess that it's not a serious problem, could be as simple as low fluid in the internal reservoirs.
Bike
Bikes going into the local bike guy to sort it out on Thursday ta for all advice
Similar threads
