I need a favour. I'd like to know the distance between the centre of the swinging pivot and the centre of the bevel box pivots on an 1150 swinging arm.
Can somebody with an 1150 take a measurement please?
- Thread starter Rob Farmer
- Start date
RIXTER
Registered user
measurement
Hi Rob, Roughly 517 mm.Cheers, Rick.
Hi Rob, Roughly 517 mm.Cheers, Rick.
Thanks Rick 
Just measured the one I have lying in the garage and it appears to be 343 mm
I didn't explain very well.
It's the measurement between the two pivots 6 & 6 in this picture
It's the measurement between the two pivots 6 & 6 in this picture
Rob,
34cm centre to centre.
34cm centre to centre.
RIXTER
Registered user
measurement
Sorry Rob, I took it to be between the swing arm pivot & the centre of the hub.
Sorry Rob, I took it to be between the swing arm pivot & the centre of the hub.
Great Stuff. Thanks
Could somebody with an 1100 take the same measurement please.
I'm looking at the possibility of swapping out the backend in a Paralever airhead project. The Paralever swinging arm is 290 between the pins so the 1150 swinging arm will give a 2" extension.
I'm looking at the possibility of swapping out the backend in a Paralever airhead project. The Paralever swinging arm is 290 between the pins so the 1150 swinging arm will give a 2" extension.
Canuck
Registered user
353mm ... or so I made it. Roughly centre to centre though could be a few mm either way as I don't have anything more precise than a measuring tape and two eyeballs. I would have thought both bikes would have been closer though... 34cm and 35 seems to be a silly difference if you could get away without changing the dimension of a part... can both parts be interchanged between models? Anyone...?
I would have thought both bikes would have been closer though... 34cm and 35 seems to be a silly difference if you could get away without changing the dimension of a part... can both parts be interchanged between models? Anyone...?Welshman
Registered user
353mm ... or so I made it. Roughly centre to centre though could be a few mm either way as I don't have anything more precise than a measuring tape and two eyeballs.
They kept the wheelbase the same when they brought out the longer 6 speed box so yes shorter swing arm
Huh !!!! Paralevers
As long as you don't bugger up a perfectly good mono to do it .
.
Huh !!!! Paralevers
As long as you don't bugger up a perfectly good mono to do it .
.
Of Course it's a mono frame. Got a big angle grinder ready to start carving the frame up...wouldn't do to damage a precious Paralever frame now would it.
Of Course it's a mono frame. Got a big angle grinder ready to start carving the frame up...wouldn't do to damage a precious Paralever frame now would it.
BARSTARDIO..
BTW, you going to sycos in Ironbridge????
It's about time I got you pissed again
BARSTARDIO..
BTW, you going to sycos in Ironbridge????
It's about time I got you pissed again
Half a cider should just about do it
I still can't face drinking any sort of cider after you poisened me at Lumbs.
Similar threads
