Morning all,
The centre stand on my 18 plate 1200gsa is looking very shabby and I’d like to remove it, get it blasted and powder coated. I did the same on my last bike and had a nightmare removing and replacing the return springs. Does anyone have a technique/knack for getting them off/on. I fabricated a t-bar to pull them off last time and found I’d wasted my time as I wasn’t strong enough to budge them.
All advice appreciated.
The centre stand on my 18 plate 1200gsa is looking very shabby and I’d like to remove it, get it blasted and powder coated. I did the same on my last bike and had a nightmare removing and replacing the return springs. Does anyone have a technique/knack for getting them off/on. I fabricated a t-bar to pull them off last time and found I’d wasted my time as I wasn’t strong enough to budge them.
All advice appreciated.