Clutch remote bleed adaptor

[beermonster]

Am having problems removing the grub screw whych was already rounded and is now well and truly tossed. After searching this site it would appear that this is a common problem.

One soloution that was suggested was to drill the bugger and use an extractor. Failing that I notice that the adaptor appears to come in two halves, is it possible to buy the bit containing the grub screw as a seperate item?

 

[delpel]

Dude,

I had the same on my R1100S. I just seperated the 2 halves and replaced the end with the grub screw in with a standard stainless steel bleed nipple.

Speak to Darren at Motorworks and he will give you the exact thread size etc.

Hope that helps.

 

[Steptoe]

Unscrew the whole bleed unit and replace with a bleed nipple .

 

[beermonster]

Thanks chap will get one today, a much better proposition than drilling.

 

[GEOFFREY DEACON]

nipples

While your at It ,,change the brake nipples as well,,(same unit)..

 

[Steptoe]

While your at It ,,change the brake nipples as well,,(same unit)..

Not all bikes use the same unit - only some 1100,and it's only on the R/H front caliper - everyone loves a smart arse