Took a while, mainly because deliveries from Motorworks were a bit slow, but all back together now.
I'd forgotten just how tight the tolerances are on the throttle cables when you're fitting new ones, ALL of them needed to have the adjuster wound right in to get the left side cable to have any slack at all. Obviously the butterfly cable run and spring needed a good clean too which helped a lot.
But now all running well, and i took the opportunity to get the tickover right too, it's been idling too fast for a while.
Looking forward to doing some riding now, and getting on with work on the other bikes!
I'd forgotten just how tight the tolerances are on the throttle cables when you're fitting new ones, ALL of them needed to have the adjuster wound right in to get the left side cable to have any slack at all. Obviously the butterfly cable run and spring needed a good clean too which helped a lot.
But now all running well, and i took the opportunity to get the tickover right too, it's been idling too fast for a while.
Looking forward to doing some riding now, and getting on with work on the other bikes!
