Denali D2 connections

[chrismckay]

Hello Guys,

I am contemplating purchasing a set of Denali D2 lamps for my RT1200 2013

I have had a quick look online at the wiring diagram and I need to do the following wiring from the "controll box"

I need to connect to a switched 12v supply via a pozi-tap

I need to connect to the motorcycle high beam wire via a pozi tap

This sounds simple enough until I started reading up on Can-bus, if I just tap into the wires as described will I end up with faults elsewhere in the electrical system?

To be honest Can-bus is alien to me

Can anybody advise me please....

Chris.....

 

[Deleted account 260111001]

Give Mike a ring at Sportrouring?

I was going to get them for my 2013 RT but ended up getting a new RT.

If I recall, you can get a tap from side light (unplug bulb, put tap in and replace bulb) for the low intensity, then a switch on bar for full (or take feed from main beam).

Relays and feeds are needed rather than drag full power from existing.

 

[theloudbloke]

Check out the thread on the CANOpener.

Ted

 

[chrismckay]

Hello Guys,

If you have time could you have a look at the diagram on the 3rd page here and let me know if this would be ok and trouble free...

http://d1l4i7f87txqmq.cloudfront.ne...ctions/Denali/D2/Instructions_TT-D2_rev01.pdf

Chris...

 

[Deleted account 260111001]

What did mike say?