fastway peg adjustment

[ianh]

Hi all. I have a set of Fastway pegs on my 1100.
Have tried a search with no luck.
Despite my best efforts, I am unable to figure out how they can be adjusted. I understand that they can be lowered 1" (or perhaps they already are?)

I've asked Nippy Normans but didn't really pick it up from the conversation, despite his best efforts.

Can anyone help?

Ian

 

[Timolgra]

It depends which way round you fit the pivot pin

 

[ianh]

Thanks.
I did think that, but any adjustment seems to depend on the spring location, relative to the pedal.
It looks athough they can only fit one way.

Ii'll have another go / look....

 

[cartejo5]

Its the pin as suggested if its level with the underside of the pedal its as low as it gets, its worth mentioning it takes a fair old clout to dislodge it as its an interference fit.

 

[sockpuppet]

As above.

The springs will have to be changed over (i.e. from left to right) if you change the height as they only fit on one side in each position so if it looks like it doesn't git use the one of the other side

 

[ianh]

think it's clear
Any pics??

I'll look again (again!!)

Ian

 

[sockpuppet]

http://www.mxsouth.com/fastway/fastway-footpegs-mounts-evolution-ii-series-f5-footpegs_1.jpg

See those barrels next to the springs in the photo. They are inside the footpeg when fitted.

If there is a gap between the peg and the bottom "lug" of the carrier on the bike they can be lowered as they are in the high position.

Push them out (you will need a vice for this and a bolt, they'll only come out one way) change them over (so that the bit that sticks out the top is now on the top of the peg) and refit.

 

[ianh]

Aaah, I understand that now....

Ian