Fitting an 1150 end can on a 1200?

[Husky]

I have a Titanium Remus end can for an 1150 that's in great condition and I'd like to fit it to my 1200. To keep the costs down, I was hoping to keep the downpipes/cat on the 1200 and get an adaptor pipe that would go from the end of the cat to the opening of the end can which has a very short pipe attached. I've made numerous phone calls and nothing like that appears to exist. I was wondering if anyone knew of any suppliers/pipe benders that did something that would do the job or if there are any good reasons for not trying to do it at all.

Thanks

 

[Bones]

I thought that the volume of the end can was dependant on the size of the cylinders (not the engine capacity), so a 1200 twin would have the same size can as a 600 single. Would an 1150 end can be close enough, I'm not sure. Worth a try though, good luck.

 

[st247]

I have a Titanium Remus end can for an 1150 that's in great condition and I'd like to fit it to my 1200. To keep the costs down, I was hoping to keep the downpipes/cat on the 1200 and get an adaptor pipe that would go from the end of the cat to the opening of the end can which has a very short pipe attached. I've made numerous phone calls and nothing like that appears to exist. I was wondering if anyone knew of any suppliers/pipe benders that did something that would do the job or if there are any good reasons for not trying to do it at all.

Thanks

Zorstec should be able to sort that out, in Shipley though, so a fair run out. No doubt they'd be able to advise of any issues aswell.