Fitting y piece

[Nicholas]

What is the correct way/order of doing this ? , has a quick look at where the lamda probe is and it looks to be a right bit*ch to get at.
Will probably be fitting new end can and y piece at same time.

Nick

 

[MiGSel]

On my Laser Y-piece, the probe is more to the back than on the stock item. If that's the case with yours too, the easiest way is to remove the fuel tank first, and loosen te cable that goes to the probe. You'll have to do it anyway when you fit the Y-piece. There should be some extra cable under there in a loop.

So if you loosen it first there, you can remove the cat and take it off before you remove the probe. That solves the problem of reaching it.

Cheers,
Michel

 

[bakerlonglegs]

Have a look here

Someone did post a guide to fitting a Y piece a while back:

http://www.ukgser.com/forums/showthread.php?s=&threadid=2326

I've just tried to load it and the photos seem to be missing but at least the words should help!
I didn't need to take the tank off to fit my Sebring (=remus) Y piece, just unclip the sensor wire from the side of the engine.
Andy