brianski
Guest
Does anyone know how to adjust the position of the gear lever. Mine is a bit too high, i thought about stickin a block of wood to my boots but i don't think that would look too clever
Brian,
the vertical link has a screw thread adjustment on it...
...pretty sure you'll have to undo the clip, disconnect, adjust and re-assemble to make the adjustment.
Mike
the vertical link has a screw thread adjustment on it...
...pretty sure you'll have to undo the clip, disconnect, adjust and re-assemble to make the adjustment.
Mike
the threaded rod is called a rose joint, its adjustable, undo the lock nuts, and turn it to move the lever up or down.
iletts
Registered user
that takes me back to the 70's and the days of 'Custom Car' - got loads of back issues in the garage, go for a tommy tank now and then..........rose joints...............aaahhhhh
brianski
Guest
Many thanks guys, I'll give it a go.
Pedantic mode :
No it isnt called a rose joint.
Rose were the name of one of the first companies to make rod end bearings.
Rod ends can be male or female threaded or a push-in insert
Rose is to rod ends
as
hoover is to vacuums
No it isnt called a rose joint.
Rose were the name of one of the first companies to make rod end bearings.
Rod ends can be male or female threaded or a push-in insert
Rose is to rod ends
as
hoover is to vacuums
Similar threads
