GS FOG LIGHT KIT

[Pablo1]

any advice on this or know a man who can fit.
http://rover.ebay.com/rover/0/e1103...tem=260661346205&ssPageName=ADME:B:EF:GB:1123

 

[Deleted account 190920001]

fit them yourself, its the original kit and simply plugs in.

 

[Pablo1]

r u serious im feckin clueless , r u saying theres an used plug already on bike somewhere ? also dont i need a switch.

 

[Deleted account 190920001]

Yes there are sockets under the tank and it all plugs in. the switch is included although it doesn't say what the switch is. It will either be the type that goes on the handle bar clamps (early type) or a new back for the left hand switch gear. Course that assumes you have a 2008 + bike. If you have an earlier bike then a bit of wiring will have to be done but nothing major.

 

[Deleted account 190920001]

Should add remember if your 2008+ then a trip to the dealer is needed reprogram according to the add. If your older than that then you wont have to do that but by the sounds of it you will have to pay someone to install them if you really don't have a clue about electrics.

 

[Pablo1]

Thanks matey Im going to have a go

 

[Pablo1]

do i need to remove the tank ??

 

[Taff]

r u serious im feckin clueless ....

.... Im going to have a go

Hang around folks; this could get interesting.

 

[Deleted account 190920001]

do i need to remove the tank ??

Yes, the sockets are under there.

 

[Pablo1]

Yes, the sockets are under there.

Thanks again Mark

 

[Pablo1]

Yes, the sockets are under there.

Feck that , Ive gone for these bad boys instead ,
http://www.mv-motorrad.de/lshop,sho...,001.001_035,1124,,Tshowrub--001.001_035,.htm

 

[Pablo1]

http://www.mv-motorrad.de/lshop,sho...,001.001_035,1124,,Tshowrub--001.001_035,.htm