GS screen on a GSA

[Victor c]

Hi all

Will a 1200gs screen fit directly on to a 1200gsa without the need to change any of the spacer washers on the sides?

 

[autogs]

yep sure wll.

 

[Victor c]

yep sure wll.

Great thanks

 

[ballistic]

yep sure wll.

But I think you'll need to drill 2-holes for the GSA upper support, won't you?
This is the cut-down standard GS screen that I used in Morocco (for more airflow)...

 

[Victor c]

But I think you'll need to drill 2-holes for the GSA upper support, won't you?
This is the cut-down standard GS screen that I used in Morocco (for more airflow)...

Was thinking about removing the upper support bar frame, or maybe bonding on a couple of rubber buffers rather than drilling holes.

 

[Arctic Fox]

BMW don't think you need the additional support on the GS screen, don't quite know why others think you do. I actually swapped my GS screen for a GSA one, as I wanted somewhere to hang the GPS and the previous owner had put a really tall screen on. Interestingly the 'vibes' don't appear any different but I guess its stronger.

So if you don't need the bar to support your GPS, suggest you remove it as planned.

 

[Bendy toy]

I have one of these going begging -

http://wunderlich.sportouring.net/w...ch=r1200gs&category_id=1632&sub_category=true

 

[Victor c]

Thanks for all the replays guys. It fitted without too much issue. I removed the extra support brace and had to add a 3mm spacer to the inside of the side adjuster nuts to hold them slightly out of the adjustement channel.

Had a good run out today and much prefer the lower screen with winglets. More airflow around and through my helmet vents and quieter.