GSA Rear light

[Scott ferguson]

Right people I'm having a bit of a moment. After purchasing an led light panel from NN the time has come to fitting it, I've removed the light unit from the bike but how does it come apart ? there's no obvious screws & the plastic looks a little brittle to start forcing it. The bikes a 2008 GSA.
Thanks
Scott

 

[autogs]

hasnt a 2008 already got a led rear lamp

 

[Scott ferguson]

Yes, but for the love all things bright I bought a NN super Bright version. Looking on his site it states it will fit GSA all years, not so sure now.

 

[Pete1200]

Hi, if my experience is anything to go by then it is straightforward. Undo the 2 screws holding the lens, remove it and then the bulb. If the panel is already assembled onto the " bulb base" undo the screw in the centre of the LED board and then insert "bulb base" into the bulb holder. Note that the pins should be offset so that it will only fit one way round. Screw the LED board back onto the " bulb base", making sure that the board is in the right position, ie, long flat side horizontal to the bottom. Mine also came with 2 little pieces of plastic that go on the sloping sides. Refit lens and check operation.
Hope this helps.

 

[autogs]

i think you will find the nn led inserts fit up to 08,as far as i know the bm ones are sealed.