Help, bolting back the plastic

[FD2]

So, after a nightmare where I realised I had bought an expensive bit that wouldn't do the job I wanted (and couldn't be returned) I started bolting back all the plastic on the 1250GSA (beak, tank cover, the bulbous bits on the sides). Then I knocked over the table where I had put all the marked bolts.. SO, anyone got anything that describes where the long. short, collared etc bolts go? I'm due a break..

Thanks

 

[autogs]

www.real oem put your chassis number in and find the part you need to bolt on and the size and length of the fasteners is listed

 

[FD2]

Thank you!

 

[batman1]

A rough clue....the screws without collars go through single sheet plastic, the ones with collars go through two sheets of plastic.

Don’t overtighten!

 

[iandavid]

Been there done that. Thats why now I always take a picture of each fastener before I take it out.