Heppco and Becker crash bar fitting.

[gsman1]

How hard are these to fit, do you have to supprt the engine etc when removing any of the bolts.

 

[Deadskin]

Easy peasy

I followed GS Monkeys instructions,
mine fitted with out the need to support the engine,
they had the elongated holes,
just make sure you sand down the ends that fit in the middle bit...

 

[MATKAT]

even I could do it

took about 10 minutes to fit. No problems just do one side at a time. Mind you i did not fit the two really small securing screws on the cross brace, didnt seem neccesary.

 

[TheJoker]

If you do a search, you'll find a huge thread where Clive explains how it's done.

 

[Mouse]

It's in the FAQ, in the FAQ section!!