How hard are these to fit, do you have to supprt the engine etc when removing any of the bolts.
Heppco and Becker crash bar fitting.
- Thread starter gsman1
- Start date
Deadskin
Registered user
Easy peasy 
I followed GS Monkeys instructions,
mine fitted with out the need to support the engine,
they had the elongated holes,
just make sure you sand down the ends that fit in the middle bit...
I followed GS Monkeys instructions,
mine fitted with out the need to support the engine,
they had the elongated holes,
just make sure you sand down the ends that fit in the middle bit...
MATKAT
Registered user
even I could do it
took about 10 minutes to fit. No problems just do one side at a time. Mind you i did not fit the two really small securing screws on the cross brace, didnt seem neccesary.
took about 10 minutes to fit. No problems just do one side at a time. Mind you i did not fit the two really small securing screws on the cross brace, didnt seem neccesary.
TheJoker
Registered user
If you do a search, you'll find a huge thread where Clive explains how it's done.
Mouse
Registered user
It's in the FAQ, in the FAQ section!!
Similar threads
