High mileages 1150

in reality, in my mind it does not matter whether you use mineral or semi synthetic oil, i just have always used Rock oil in my bikes. i used fully synthetic oil in the gearbox as i feel that it makes the gearbox smoother... just my observation.
if you change you oil regularly and use the bike nicely from cold until it has warmed up properly all should be fine. try to avoid lots of short journeys as this knackers oil quickly as it does not heat up fully and emulsifies.
 
2000 GS, 114,000 miles. Just finished 2000+ miles on the TransAmerica Trail, then 2600+ miles on pavement to get home. Flawless performance.

Only major replacement was the Hall Sensor.
 
Bumped into a mate i hadnt seen for 3 years a few days ago and his GS 1150 has just hit 115,000 but then the reason i hadnt seen him is he was not long back from a 2 up round the world trip on the bike :bow

4 rear final drives was his main replacement bit


I have put 3000 miles on in the 2 months of ownership but its still a baby at 23,000 on an 03 model
 
.

Lets guess..... must be Nick and Lesley. Well done to them and much respect due, their website is a great read too.:thumb
 
Lets guess..... must be Nick and Lesley. Well done to them and much respect due, their website is a great read too.:thumb

Aye, that would be them, cracking couple and Nick told me about their upcoming plans for some more travel :thumb2

Just makes want to get to my retire point sooner and get off on the bike myself for weeks on end (not quite got round the world plans but certainly start on a Europe tour) :)
 
I was a bit concerned to see my new to me Sept 05 1150GSA turned the 2000 miles mark on the way home from work tonight :D
 
Worn out now

I was a bit concerned to see my new to me Sept 05 1150GSA turned the 2000 miles mark on the way home from work tonight :D

E-bay Quick or I'll give you a tenner for it unseen.
dave Gs.
 
I was a bit concerned to see my new to me Sept 05 1150GSA turned the 2000 miles mark on the way home from work tonight :D

Got to agree with DaveGS.

With so little use over the years it'll be all rusty inside. Sell quickly. I'll take a chnace and give you a £100 to use it for parts:augie

Mine is just about run in at 54,000+ One output final drive bearing and seal, an input seal but replaced the bearing and paralever pivot bearings whilst it was stripped. 2 stick coils 3 sets of front discs (2 sets under warranty because of pitting in the first and a high spot on the second) 1 rear disc + service parts
 


Back
Top Bottom