HT Leads

[Monkey Man]

Hi all
Does anybody know any shops online who have pre-made HT leads for a twin spark r1150gs? I think i may have a slight prob with my lower secondary set as i seem to get a open circuit when i test them on my multimeter and i think it should make continuity? Ive tested the coil and the resistance is fine but the spark seems a little weak on both.

 

[ianboydsnr]

Hi all
Does anybody know any shops online who have pre-made HT leads for a twin spark r1150gs? I think i may have a slight prob with my lower secondary set as i seem to get a open circuit when i test them on my multimeter and i think it should make continuity? Ive tested the coil and the resistance is fine but the spark seems a little weak on both.

I thought the secondary twin spark leads and coils were just the single spark main leads and coils, so look on motorworks or sherlocks for those

 

[Monkey Man]

Thanks for the reply, i was looking at those on the motorworks site but they seem to have long plug ends simlar to the primary coil sticks. Would they not stick too far out on the secondary lower plug?

 

[ianboydsnr]

could you not just buy some new cable off ebay like this

http://cgi.ebay.co.uk/BLACK-HT-High...14&_trkparms=72:1683|66:2|65:12|39:1|240:1318

and screwthe old fittings on, or buy new caps

http://cgi.ebay.co.uk/NGK-Plug-Cap-...14&_trkparms=72:1689|66:2|65:12|39:1|240:1318

you may have to ring motorworks, as they are unlikely to be on the website, or go directly to the manufacturer

 

[Steptoe]

secondary plug caps are shorter than the main single spark caps, you may be able to make your own lower twin spark using an NGK plug cap.