After having the bike for a little over a year, I finally got my act together and fitted cameras to it. I thought I'd create this thread because I ended up taking quite some time researching on the web in general trying to decide which system to go for and then where would be best to mount the cameras. In my mind, partly because the bike is still under it's warranty but also because I knew I would want to power other accessories in due course, I opted to run it through a Hex Ezcan.
After much consideration I decided to go with the Innovv K7.
I apologise that I didn't take any pictures of the actual fitting but there was nothing out of the ordinary with regard to the routing of the wires and the position of the Hex under the pillion seat. It is a bit cosy under there with all the wires, so removing the pannier rails and the silver trim tail section makes life a bit easier.
Here's some pictures of the mounting position for the cameras and a still of the view from them.
Front Camera
Rear Camera. Slightly blurred but mounted on the underside of the Givi rack.
Hope that helps anyone in a similar position.
After much consideration I decided to go with the Innovv K7.
I apologise that I didn't take any pictures of the actual fitting but there was nothing out of the ordinary with regard to the routing of the wires and the position of the Hex under the pillion seat. It is a bit cosy under there with all the wires, so removing the pannier rails and the silver trim tail section makes life a bit easier.
Here's some pictures of the mounting position for the cameras and a still of the view from them.
Front Camera
Rear Camera. Slightly blurred but mounted on the underside of the Givi rack.
Hope that helps anyone in a similar position.
