melted oil sight glass

posted

And you posted that on this thread because............?

fair cop,had a lot of probs with my gsa,my mates has being good,also had a bad bad dealer,so left bmw,have got honda,s and a trumpet,sold my much loved v-strom to get the bmw,bet its still running,but rotted to bits lol
 
fair cop,had a lot of probs with my gsa,my mates has being good,also had a bad bad dealer,so left bmw,have got honda,s and a trumpet,sold my much loved v-strom to get the bmw,bet its still running,but rotted to bits lol

I'm genuinely happy for you mate and it must be thrilling for you to have finally left this terrible brand. It must be wonderful for you that you can now come back on here and tell us how shite and unreliable our bikes really are:thumb

Thanks for your valuable and incisive input, much appreciated:thumb
 
fair cop,had a lot of probs with my gsa,my mates has being good,also had a bad bad dealer,so left bmw,have got honda,s and a trumpet,sold my much loved v-strom to get the bmw,bet its still running,but rotted to bits lol

That's all the convincing I need...............

See my R1200GSA for sale in the FS&W soon! :rob

Al
 
Melting sight glass.

It's plastic. And it's not the first time an oil sight glass has melted after a bike has been left with the engine running.

Hence the warnings in the owners handbook about it.

Try doing a search.


Why use plastic instead of glass?. Surely it can't be a cost issue. Just wondering
how the collective here deal with traffic jams in warmer climates?. :nenau
 
Glass

Tell your mate to RTFM it says not to leave it running but to start it, get on and ride it.
 
touchy

I'm genuinely happy for you mate and it must be thrilling for you to have finally left this terrible brand. It must be wonderful for you that you can now come back on here and tell us how shite and unreliable our bikes really are:thumb

Thanks for your valuable and incisive input, much appreciated:thumb

woooo a little touchy........ha ha :comfort

to be fair my comment was a bit tounge in cheek :blast

dont hate the brand at all,just had a bad egg

its a brill forum on here,so calm down dear.....lol
 
It's plastic. And it's not the first time an oil sight glass has melted after a bike has been left with the engine running.

Hence the warnings in the owners handbook about it.

Try doing a search.

You think some of 'em on here can read :eek: Steppers - later stuff is mineral glass (no red dot in the middle of the glass) on later stuff circa 2011 onwards
 
Why is the sight glass cheaper to MBW than a simple wire or flat strip dipstick as used in car engines.

Only option I can see in hot weather traffic is to fit a heat shield over the sight glass. Also avoid cheap petrol. The retarded the spark ignition throws more heat down the exhaust = more heat radiated off the pipes.
 


Back
Top Bottom