Okay - so I'm on my second set of tyres (and going to have to go to the third set very soon!). First were OE Bridgestone’s, then after 6,000 miles went to Conti Trail Attacks (very pleased with these by the way!) Now done 12,000miles. In both cases a change at the rear was brought about by to squaring off, but it is the front that is the issue.
Loads of tread. Both front tyres started to go a bit 'V' shaped, but the main issue is the blocking effect where the tread blocks are at uneven heights. They’ve both done the same - hence the new front at 6k (and again soon!).
Talking to an independent bike maintenance guy today he says this is caused by incorrectly adjusted suspension. Because the bike's got ESA I don't think I have much control over this.
Anyone had the same problem? Anyone with a bit more technical knowhow than me care to comment on the problem?
Loads of tread. Both front tyres started to go a bit 'V' shaped, but the main issue is the blocking effect where the tread blocks are at uneven heights. They’ve both done the same - hence the new front at 6k (and again soon!).
Talking to an independent bike maintenance guy today he says this is caused by incorrectly adjusted suspension. Because the bike's got ESA I don't think I have much control over this.
Anyone had the same problem? Anyone with a bit more technical knowhow than me care to comment on the problem?
.
