Non GS, fixin me old rut rat with a big copper mallet

Finesse... with a copper mallet.
two words not often seen in the same sentence. :clap

thats style. :thumb2
 
Proper engineerin!

:bow:bow if I broke down I'd rather have you fix it than 99% factory trained mechanics! :bow:bow Top 'mallet' man; once had a very expensive saxophone repaired by a guy (let me watch too) who put the slightly bent key shaft in the lathe and he had a hole drilled in the end of his hammer (non copper) which he put over the shaft (v delicate) and trued up whilst he spun it up in the lathe, :bow:bow clever begger, nice clip, all d best DM :thumb2
 
aw shucks, thanks, ye'll have me blushing in a minute.
Mind you, I might be blushing after tomorrow if it goes bang out on the trails.
 
very gentle I thought



yup, here's the extended version, about 3 minutes 30secs it gets mildly amusing, the rest was a gentle run with some first timers.





Finesse??? wassat then?

I rode past this little playground last weekend while out with cliffhanger and a few other's. this is on the top of pepper box hill isn't it?

Looks like somebody doesn't want bikes in there now. A digger has been in and put a deep trench right around the top of this crater. I'd have taken a photo or to...but breakfast at the little texaco garage was calling......
 


Back
Top Bottom