So I picked up my new WC TE a few weeks back and have done approx 125 miles to date. Turned the bike on today to move it and when I tried to turn it off the starter motor ran continuously ....er what do I do now!
The bike is keyless so if I pressed the starter button the bike would run again however when I turned the ignition off the started motor would continuously run again. After about 15 mins some smoke came off the starter motor and then the whole bike switched off and went dead...nothing nada kaput.
I'll be ringing up tomorrow however I now have a completely dead bike with I guess shagged starter motor and right side handlebar switches (kill switch button)?
I assume if I insist on the replacement of the above this will fix it however anyone seen this before and would there be potentially other damage from the continuous running at all...I assume not?
The bike is keyless so if I pressed the starter button the bike would run again however when I turned the ignition off the started motor would continuously run again. After about 15 mins some smoke came off the starter motor and then the whole bike switched off and went dead...nothing nada kaput.
I'll be ringing up tomorrow however I now have a completely dead bike with I guess shagged starter motor and right side handlebar switches (kill switch button)?
I assume if I insist on the replacement of the above this will fix it however anyone seen this before and would there be potentially other damage from the continuous running at all...I assume not?



