Paralever drive shaft

[centurion]

Hi all

Ive read loads on here. Has anyone tried the reconditioned and uprated shafts from Boxer Supplies in Holland 355 euro exchange plus carriage or should I go for a recon from motorworks ?

Any other ideas, suggestions

Regards
Centurion

 

[MickDB1]

Belper Phils had his done for a load less
He is on here and a good lad to know

 

[Ras Thurlo]

there was some recent discussion on this on ADV:

http://www.advrider.com/forums/showthread.php?t=852807

 

[centurion]

Thanks for the pointers. I have seen on the BMW boxer supplies website a part which bolts onto the 2v gearbox flange to allow you to fit an 1100 drive shaft. Does anyone have any knowledge of this.? I may ring boxer supplies to see what it entails.

Rgds Centurion

 

[DrFarkoff]

Usually entails fitting an 1100 swingarm and final drive too

Not a route that is popular due to alignment issues and having to have a rear hub off set spoked

 

[centurion]

Thanks for that, a financial non starter then.


Regds Centurion