Seat Angles

[BTBR]

Before I break something , is it possible to have the seat on the high setting at the front and the low setting at the rear

Its a normal height seat, and I have had it with the two bars in the "high" position. But the back of the seat seems to high

I have tried to lower it and it does not appear to want to fit.

Sp prehaps it shouldnt

 

[Les Wassall]

Before I break something , is it possible to have the seat on the high setting at the front and the low setting at the rear

Yes that's how I have mine, works well for me

 

[NeverRodeBefore]

Careful fella's, I was told never to fit the seat like that when I collected mine from Rainbow, and I'm sure it's in the manual?

Cheers, TonyB.

 

[BTBR]

Yes that's how I have mine, works well for me

Bugger........I better go and hit it a bit harder then..

 

[Les Wassall]

Careful fella's, I was told never to fit the seat like that when I collected mine from Rainbow, and I'm sure it's in the manual?

Cheers, TonyB.

Been told by two dealerships that's the way to do it, tried the GS at one and the ADV another

 

[Les Wassall]

Its a normal height seat, and I have had it with the two bars in the "high" position. But the back of the seat seems to high

I have tried to lower it and it does not appear to want to fit.

Sp prehaps it shouldnt

Give the rubber bung a turn at the back, before you try to clip it back down

 

[BTBR]

Careful fella's, I was told never to fit the seat like that when I collected mine from Rainbow, and I'm sure it's in the manual?

Cheers, TonyB.

To be fair it does say that in the handbook, and I have not managed to get the bastard to fit yet.

That said, I cannot get it to fit with them both in the lower position either

 

[John Armstrong]

That said, I cannot get it to fit with them both in the lower position either

Get a bigger hammer then?

Or use a metric adjustable instead of the imperial one?

 

[Les Wassall]

That said, I cannot get it to fit with them both in the lower position either

It could be the bung at the back has not given at all yet, clip in the front and put some waight on the seat, and if you've not got enough just jump on it

 

[(RIP) Shenzi]

Chamfer the edges of the relevant plastic bits and the seat will go in much easier.

 

[BTBR]

Give the rubber bung a turn at the back, before you try to clip it back down

WTF................how does that work then Did that and it has just clipped in.

Get a bigger hammer then?

Sussed it now, you need to treat it like a woman.





Give the fecker a slap after a good nights sleep.

 

[Les Wassall]

WTF................how does that work then Did that and it has just clipped in.