Shite bag fitting

[ELIMINATOR]

OK I've had this a few years now. In the past I stuck some vinyl on the petrol tank to stop the paintwork getting damaged. I used to fold over the lead edge of the bag, so that the nylon outer was up against the tank, hence the vinyl.

I loop the front restraint between the headstock & the ignition switch.

The lower straps are looped over the plastic cylinders that go from the airbox to the throttle bodies.

This time, I have fitted it the same way, except that I have not folded the shite bag, and the soft lining is on the petrol tank.

I was pondering putting the lower straps on the cylinder head side of the throttle bodies, not quite sure if it will foul against the L/H cylinder throttle cable assembly though.

Question is, how do you fit yours?

 

[ELIMINATOR]

Did a bit of searching, it should be folded over at the front, although this means that I would feel obliged to sticj the vinyl on to stop any chance of marking the tank.

I think I'll go with it as it is, and if the fluffy lining gets wet, then it gets wet. Always change it later.

 

[Wreford Miles]

I put mine on quickly....

I avoided putting the step near the ignition switch to avoid unwanted stress on the loom

 

[ELIMINATOR]

My loom has had the cable ties removed, strap is nowhere near the loom.

 

[Steptoe]

My loom has had the cable ties removed,

The first thing any sensible owner should do. Cut all the cable ties that hold and secure (too tightly) the wiring around the headstock

 

[GrinningGSer]

How about starting a sticky, 'What any sensible owner should do', but somehow limiting it to genuine sensible comments? Pearls of wisdom like above would be invaluable.