Tyres presssures

[Breham]

How the he’ll do you get the tyre pressures set so you don’t get a warning.

It seams if you are one point out above or below you constantly have a tyre warning issue. Is it me or the garage I bought it from it has never not had a warning.

I am not losing tyre pressure just getting them set is impossible.

Please tell me I am not alone?

 

[DJ123]

What pressures are you setting them to?

IIRC, if you are getting continuous notifications could be a sign a battery is low in a sensor

 

[Breham]

Well I try setting them to the recommended pressures. But I have done it manually, used tyre pressure at a gas station and every time it’s just off and always shows a warning,

It’s like if I am 0.01 psi out I have a warning. Does every one else get this

 

[DJ123]

Nope. Mine seems to be fine with a few psi either way and not flag up any issues.

 

[Neil W]

on all three of mine with TPMS they could be 3 or 4 psi high or low and not set the warning off , however, when I got a bolt in a rear tyre the warning came on within seconds of it dropping by about 6 psi

 

[Victor c]

If your bike is equipped with the TFT screen, you can set the minimum pressure trigger point for the dash warning in the bikes settings.

 

[Breham]

If your bike is equipped with the TFT screen, you can set the minimum pressure trigger point for the dash warning in the bikes settings.

That’s perfect

 

[knutk]

Honestly, I don't get it.

TPMS is a safety system, and it aims to trigger a warning to the rider in case of a sudden drop in tire pressure.

I have never had a bike that triggers a warning if the pressure is a tad too high.

It would be nice to learn from the OP how he manage to set up his system in such a way that it warns for BOTH high and low pressure...

 

[Breham]

If your bike is equipped with the TFT screen, you can set the minimum pressure trigger point for the dash warning in the bikes settings.

Hey Victor, I had an attempt, but no idea how to do this. I have looked at the manual and googled it, can you provide some insight into how to do this. If I am 0.1 psi I have a constant warning…..

 

[Breham]

Duplicate

 

[Victor c]

Hey Victor, I had an attempt, but no idea how to do this. I have looked at the manual and googled it, can you provide some insight into how to do this. If I am 0.1 psi I have a constant warning…..

In the R1250GSA handbook it is on page 89, under "Tyre pressure control (RDC).

"In the TFT vehicle settings, the system can be set to issue a specified pressure warning if the pressure drops to the defined minimum"

 

[stick]

Honestly, I don't get it.

TPMS is a safety system, and it aims to trigger a warning to the rider in case of a sudden drop in tire pressure.

I have never had a bike that triggers a warning if the pressure is a tad too high.

It would be nice to learn from the OP how he manage to set up his system in such a way that it warns for BOTH high and low pressure...

Would be good if it does , as high pressures can be as bad as low .