Vibrations

[Brig]

I have only had my gsa a week and have had an interesting time reading these pages,loads of good stuff.I have been looking at the best place to install my zumo and it would seam that whatever fitting I use I am going to get the vibes because they are all fixed to the cross bar on the screen,and the screen vibrates.
My last bike was a blackbird where the zumo was fixed onto a ram mount which fitted into the hole in the centre of the headstock cost about £35,great idea no vibes.
I guess my question is are there an unobtrusive fitting that will fit around the central handlebar area which will ,therefore,eliminate some of the vibration,I think.

 

[Bikerbrady]

Yes.....touratech make one see here

 

[RAM-man]

The Blackbird yoke mount is likely to have been a custom adapted part from one or two guys who make them.

You should find some posts and images where the zumo bracket has been attached onto the screen bracket, but I would opt to use a RAM-B-231Z (has 1", 1.25" u-bolt and the RAP-319 shim) and locate onto the oval rail, LHS of the clock plus use a wrap of rubber strip, thumb width wide as well, the cast u-bolt bracket when attached, should be facing you.

 

[HMR]

Damped RAM mount?