robroy
Registered user
I have 02 1150GS.
I can't believe I'm the only numpty with the bad habit of intermittently resting my foot on the back brake pedal, resulting in a) confusion for following drivers, b) probably an impact on fuel efficiency, and c) back brake pads wearing away at an alarming rate (and worse. Don't ask me how I know
)
I plan to rotate the rear brake pedal one notch lower (is this a bad idea???), but I'm also considering wiring a LED indicator to the brake circuit so I know immediately when I'm transgressing.
First simplistic thought is to use a 5 or 8mm panel-mounted LED and wire it via a resistor in parallel with the rear brake light. I'm not sure where I'll mount the LED yet as my bike is in the shop having rear brakes repaired.
Does this sound feasible to you experts out there? Is there a better place to wire it in? Wiring it to the rear brake switch only would be better to reduce the "false positives" that could become annoying in traffic.
All ideas considered.
Thanks guys,
Rob
I can't believe I'm the only numpty with the bad habit of intermittently resting my foot on the back brake pedal, resulting in a) confusion for following drivers, b) probably an impact on fuel efficiency, and c) back brake pads wearing away at an alarming rate (and worse. Don't ask me how I know
I plan to rotate the rear brake pedal one notch lower (is this a bad idea???), but I'm also considering wiring a LED indicator to the brake circuit so I know immediately when I'm transgressing.
First simplistic thought is to use a 5 or 8mm panel-mounted LED and wire it via a resistor in parallel with the rear brake light. I'm not sure where I'll mount the LED yet as my bike is in the shop having rear brakes repaired.

Does this sound feasible to you experts out there? Is there a better place to wire it in? Wiring it to the rear brake switch only would be better to reduce the "false positives" that could become annoying in traffic.
All ideas considered.
Thanks guys,
Rob
Last edited:

