I have a slight leak from my water pump, does anyone know which parts will need replacing and best place to source please.
Many thanks.
Many thanks.
Water pump
- Thread starter FERRET
- Start date
I used Motorworks and probably bought more than needed as I didn't know for sure which gaskets and bearings I'd change while in there. It is an absolute sod to do and it was thanks to the illustrious Mr J. Nicholson that it gone done as quickly as it did - or possibly at all. Parts I bought included the below. It might be a good opportunity to replace hoses while you're at it.
It's a brilliant bike but amongst the most stupid of designs for this job.
| Coolant pump impeller and seal kit SKU: COA43451-2 |
| Coolant pump gasket seal SKU: COA52950-1 |
| Coolant pump sprocket washer SKU: ENA43107-2 |
| Coolant pump drive gear roll pin SKU: ENA43127-1 |
| Coolant pump drive pinion SKU: ENA52905-1 |
| Clutch cover gasket SKU: ENA52946-2 |
| Gear selector shaft oil seal SKU: GEA43038-1 |
| Clutch actuation shaft needle bearing SKU: CLA43036-1 |
| Clutch actuation shaft needle bearing SKU: CLA43037-1 |
| Clutch housing cover gasket outer SKU: ENA99390-1 |
Thanks for that, yes looked it up on YouTube, does look a bit of a mare.
Water pu
O question. Our new pump hero’s coming on randomly. Error message suggests a leak. Under instruction from plumber I’m going to watch it today. Can you explain the difference between these two bar settings?
D stays constant. H fluctuates when no taps running. Stop cock then opens to add water. Going to isolate both the hit and cold pipes over the course of day but wondering what these are? H is current bar? And where?!! D is the desired bar pressure I want the pump to run at?
It’s nippy up here in the attic
O question. Our new pump hero’s coming on randomly. Error message suggests a leak. Under instruction from plumber I’m going to watch it today. Can you explain the difference between these two bar settings?
D stays constant. H fluctuates when no taps running. Stop cock then opens to add water. Going to isolate both the hit and cold pipes over the course of day but wondering what these are? H is current bar? And where?!! D is the desired bar pressure I want the pump to run at?
It’s nippy up here in the attic
Attachments
Owen,Water pu
O question. Our new pump hero’s coming on randomly. Error message suggests a leak. Under instruction from plumber I’m going to watch it today. Can you explain the difference between these two bar settings?
D stays constant. H fluctuates when no taps running. Stop cock then opens to add water. Going to isolate both the hit and cold pipes over the course of day but wondering what these are? H is current bar? And where?!! D is the desired bar pressure I want the pump to run at?
It’s nippy up here in the attic
Wrong section.
You've posted this in BMW singles technical section
I know! It’s a bit funny
Similar threads
