Wapping, sorry for all these posts on the 396... but I got a bit obsessed with learning how to use it properly
Quick one:
When I connect the Garmin to my Mac, via the USB cable, it asks on the screen to go into storage mode, all good.
It then goes into storage mode, Garmin logo on the screen + computer illustration, but it takes ages (a few minutes) to appear on the computer.
I suspect it does some operations before actually going into USB storage mode, but it is quite annoying if you have to disconnect it a few times (say, you are trying new maps, or uploading and testing routes, etc) as you have to wait 3/4 minutes every time before the computer and basecamp can see it as a volume.
This happens on both my computers.
Is this happening only to me? Or is it standard (bad) behaviour.
thanks
Quick one:
When I connect the Garmin to my Mac, via the USB cable, it asks on the screen to go into storage mode, all good.
It then goes into storage mode, Garmin logo on the screen + computer illustration, but it takes ages (a few minutes) to appear on the computer.
I suspect it does some operations before actually going into USB storage mode, but it is quite annoying if you have to disconnect it a few times (say, you are trying new maps, or uploading and testing routes, etc) as you have to wait 3/4 minutes every time before the computer and basecamp can see it as a volume.
This happens on both my computers.
Is this happening only to me? Or is it standard (bad) behaviour.
thanks