neil p
Registered user
....at least i think it is.
Out and about on my GS para yesterday and after a brief stop it failed to start.
turning over OK, fuel Ok, but no spark.
Off with the tank. Everything looked OK and connected but the ignition control unit and its heat sink were very hot.
When i took it off there was no evidence of the conductive paste to the heat sink.
i have ordered a replacement BUT should i be looking for a seperate cause/problem.
Is it possible just the unit itself has failed ?
i am asking because i dodn´t wish to damage the replacement.
Thanks.
Out and about on my GS para yesterday and after a brief stop it failed to start.
turning over OK, fuel Ok, but no spark.
Off with the tank. Everything looked OK and connected but the ignition control unit and its heat sink were very hot.
When i took it off there was no evidence of the conductive paste to the heat sink.
i have ordered a replacement BUT should i be looking for a seperate cause/problem.
Is it possible just the unit itself has failed ?
i am asking because i dodn´t wish to damage the replacement.
Thanks.