Yellow Peril
Registered user
I know how dead easy to fit but where on earth do you stick the connection of all the wires?
Autocom & Multitec
- Thread starter Yellow Peril
- Start date
GSrich
Registered user
Shaun,
When I fit the Shoei's at work I flex the inner and out shell of the helmet apart towards the back of the helmet with a scaple handle but you could use a fork or spoon handle and drop the loom down between the two parts. you can also do this to hide the wire to run the speaker to the other sdie of the lid.
Rich
When I fit the Shoei's at work I flex the inner and out shell of the helmet apart towards the back of the helmet with a scaple handle but you could use a fork or spoon handle and drop the loom down between the two parts. you can also do this to hide the wire to run the speaker to the other sdie of the lid.
Rich
Yellow Peril
Registered user
Many thnaks Rich that what i was thinking but just wanted to know i was on the right lines from some one with more experience. 
GSrich
Registered user
No probs at all, also if you run the neck collar I normally run a strip of velcro over the loom just to give it a bit more strength.
Rich
Rich
Similar threads
