Bevel box-swingarm bearing

[Paradiso]

Hi, can anyone recommend a bearing puller type/supplier for the bevel box to swingarm bearing outer race? I found this pic on Joerg's site:

http://homepage.sunrise.ch/mysunrise/joerg.hau/mot/img/gs80rear02.jpg

I've been to Machine Mart, but they did not have anything suitable.
Regards
Simon

 

[bustupbiker]

Any good tool supplier will stock stuff from Sykes Picavant ( er! is that how you spell it ) ? Sykes do a kit or bits to fit standard two/three leg pullers.

 

[Howard Millichap]

I managed to kock mine out with a drift from the opposite side.

 

[(RIP) Bin Ridin]

What about expanding a rawlbolt in the bearing and then punching it out?
(Old wheelbearing trick)....

 

[Sylvester]

I did'nt bother with a puller either. Just heated that bad boy up with a hot air gun and drifted them out wth a punch. They came out soooo easy. Put he new bearings in the same way.

 

[Spout]

Find a socket of the correct diameter.
Insert socket in through driveshaft hole.
Connect socket extension arm to socket (through opposite side bearing hole).
Knock out.

 

[Paradiso]

Thanks for the replies. I'll see if I can get it out without spending lots on a puller.
Cheers Simon