Brake failure 1150 adv

[twodogs]

I am getting a brake failure warning up after riding 10-15mile every time i go out and the back brake stops working as in no servo, but front works fine.

I have tried the usual, and replaced the rear pads, stop/tail light and battery but to no avail its still happening, fluid levels are ok as well

just wondered if anybody could suggest anything else before i hot foot it to my dealer.

Both brakes work fine when i initially set off but after 10-15mile it all starts to go wrong again.

any ideas would be appreciated.

 

[Pekkavee]

I am getting a brake failure warning up after riding 10-15mile every time i go out and the back brake stops working as in no servo, but front works fine.

any ideas would be appreciated.

Very strange.

The only thing i can think of is that you have some bad contack in your tail/brake light circuit. It warms up and gives a bad contact

Pekka

 

[DollyRocket]

Need to plug it into the computer to see what fault codes the servo has registered. I had something similar a year ago, basically, my circuit board had fried on the servo and needed a complete servo replacement. Wasn't too bad, bought one from the site for £100 and £50 to fit.