Hi folks,
took my 2011 1200 GSA Twincam out this morning and the brake failure light was flashing. Didn't go off after a few meters but stays on. Lost ABS at back wheel at one point then came back. Not sure about front. Braked hard on the back to test it and it cut in but stalled which may or may not be connected. there is no ABS warning light but the ASC is sometimes flashing and the words "Brake Failure are flashing red on the top display.
Disconnected the battery and read the manual in case I've pressed something by mistake. No new tyres fitted or stones jammed in the abs ring etc.
Any advice would be welcome before I have to go to the dealer.
Ta
Kev
took my 2011 1200 GSA Twincam out this morning and the brake failure light was flashing. Didn't go off after a few meters but stays on. Lost ABS at back wheel at one point then came back. Not sure about front. Braked hard on the back to test it and it cut in but stalled which may or may not be connected. there is no ABS warning light but the ASC is sometimes flashing and the words "Brake Failure are flashing red on the top display.
Disconnected the battery and read the manual in case I've pressed something by mistake. No new tyres fitted or stones jammed in the abs ring etc.
Any advice would be welcome before I have to go to the dealer.
Ta
Kev