clearing fault codes

[Bill]

Hi,

I've been checking and adjusting myTPS and I was told that if it goes above a certain voltage a fault is logged in the module.

How do I clear the fault codes?

 

[Steptoe]

Don't know what bike you've got - but i'll have a guess.

Pull fuse 5, clears the motronic of fault storage. Don't forget to re-set the motronic memory of the TPS range after you've replaced the fuse.

 

[Bill]

Thanks Steptoe.

Its an 1150 Adventure.

<Don't forget to re-set the motronic memory of the TPS range after you've replaced the fuse.>

How do you do that?

 

[Bill]

I meant, how do you reset the motronic memory?

 

[Rob Farmer]

You waggle the throttle a bit. Just wind it fully open and closed a few times after you put fuse 5 back in.

 

[Mzokk]

You waggle the throttle a bit. Just wind it fully open and closed a few times after you put fuse 5 back in.

With the ignition on but the bike not started

 

[Bill]

Thanks chaps!!!!