For some reason my cruise control has stopped working, everything else is fine and there is no fault code showing. I was off roading all weekend so whether something has been dislodged I don’t know, anyone else had this?
For some reason my cruise control has stopped working, everything else is fine and there is no fault code showing. I was off roading all weekend so whether something has been dislodged I don’t know, anyone else had this?
Does it not turn on on the switch or does it turn on but you cannot set the speed??For some reason my cruise control has stopped working, everything else is fine and there is no fault code showing. I was off roading all weekend so whether something has been dislodged I don’t know, anyone else had this?
What mode are you in? JJH
SO more likely the switch isn't turning it on so don't worry to much about sensors at this stage I reckonI know it doesn’t work in enduro, I had a new switch under warranty in 2019 but my bike has done over 100000kms. I’m not sure where the sensors for it is so will start with the switch cleaning. At the moment it does nothing at all, no lights, nothing.
SO more likely the switch isn't turning it on so don't worry to much about sensors at this stage I reckon
As Santa mentions though the whole grip will probably need replacing if it cannot be repaired (If I remember rightly the left is far cheaper than the right)That’s what I’m hoping, it worked for a while coming back from Wales, then I stopped for fuel and it didn’t switch back on. Just washed the bike so will dry it and strip the switch.
I had a similar situation with my 2014 GSA
Dealer suggested I spray a tiny spot of WD40 into the switch and if that didn't get it working they would replace the whole switch pack for new under warranty
I tried the WD40 option and that cured it![]()

see post #8Daft question but Cruse control dosent work in Enduro? Have you swapped back to another mode after offroading ?
Cleaned it and lubed it so will see what happens.