Early paralever 80GS rear brake switch cable routing ??

[Grantiii]

Hopefully one of you nice forum members could help me!!
After major strip, the nice bit.....
Attaching everything to nice powder coated frame.
Including overhauled final drive & gearbox + other pretty vapour blasted parts.....All thanks to the Great Mikeyboy

Just re-bushed rear brake lever, refit & set up the micro switch.
Now, where does the cable exit & somehow not foul the paralever pivot area, on it's way up the frame.
There is a hole below switch & a slot next to where brake cable attaches, where cable is in pic !
No obvious route from either. A pic attached to explain. Thanks.... Ian

 

[mikeyboy]

It comes out where you have it now,
Then loops around behind.
A cable tie fixes here

 

[mikeyboy]

Then the electrical connector passes through here

 

[Grantiii]

Thanks Alot Mike.....
I thought that may be the case....its just pretty damn poor, with proximity of paralever pivot point. Happen I can bolt a wee 'P' clip using that hole.
On rear bumper there is a plastic clip which secures cable with a cable tie are these clips available ?

 

[mikeyboy]

Thanks Alot Mike.....
I thought that may be the case....its just pretty damn poor, with proximity of paralever pivot point. Happen I can bolt a wee 'P' clip using that hole.
On rear bumper there is a plastic clip which secures cable with a cable tie are these clips available ?

The one on the rear mudguard is simply a zip tie through a plastic washer

 

[Grantiii]

Thanks Mike..... thats me sorted
Thread Closed