Front Disks

  • Thread starter Thread starter XRM
  • Start date Start date

XRM

Guest
Removed the front disks, aware that there could be washers behind the disks. There were, but only 4 on one side and three on the other - why not 5 on either side?

They are very thin but appear to be metal rather than hard rubber.

Anyone else seen this ?

Thanks

Rob
 
Hope you made a note of the position of each:augie
and marked an index on the discs:pullface

Just kidding but why on earth would there not be a full set unless someone was trying to align the discs in some way?
 
Fortunately I did note the position of the disks and washers, but if they are for alignment it will not apply to the new wheels.
 
I would ask a BMW dealer as I think i can remember 2008 or 2009 that there was some problem with these washes breaking up and falling out???
:rob
 
What year is the bike ?. There's a difference between the discs post and pre 2008.
 
It's a 54 plate - registered February 2005.

I know that later bikes had anti -squeel washers under the disks, but not sure if it is those that are fitted.
 


Back
Top Bottom