GSA Tooltube mounting.

[Gundog]

Just spent a very pleasent hour mounting my new tooltube on my gsa.
Fink it fits quite neatly inboard of right hand pannier, bolted to pannier rails.
Has anyone fitted one anywhere else on a gsa ?

 

[claw]

Neat Job, where did you get the tooltube and the mounting brackets. Did they come with the tube or is it a DIY fitting kit?

 

[Wanderer]

Looks very professional. Two v. small questions/points: (1) it's going to get plastered with spray from the tyre and (2) can you easily get tools in and out of it, or does the reg' plate get in the way?

 

[Gundog]

Neat Job, where did you get the tooltube and the mounting brackets. Did they come with the tube or is it a DIY fitting kit?

tooltube was a chrissy present, i made the mounting brackets meself...
No 8 cable clamps, bit of 1/4 flat bar and some stainless nuts and bolts.

 

[Gundog]

Looks very professional. Two v. small questions/points: (1) it's going to get plastered with spray from the tyre and (2) can you easily get tools in and out of it, or does the reg' plate get in the way?

yes tis goin to get dirty off back tyre, but its made of plastic and mounted on stainless steel brackets so doesn't really matter.
the lid just touches the back of the number plate when you remove it, but its not a problem...

 

[(RIP) Nakambale]

that's where I've got mine too although slightly higher up to get extra clearance. Just took it off again as I'm not entirely happy with my mountings although I'm struggling with where else to put it