Lambda sensors

[Ian]

Hi. My first post on here should be straight forward. Have bought a remus full system. Is it needed to connect the sensor plugs or not.

Thanks

 

[2 wheel humvee]

Hi. My first post on here should be straight forward. Have bought a remus full system. Is it needed to connect the sensor plugs or not.

Thanks

Short answer-yes

 

[Bendy toy]

Unclip the Lambda plugs under cylinders and disconnect the sensors. Screw sensors into headers and reconnect wires then clip back under cylinders. The leads are long enough - just.

 

[oddshapedballs]

Unclip the Lambda plugs under cylinders and disconnect the sensors. Screw sensors into headers and reconnect wires then clip back under cylinders. The leads are long enough - just.

....or, fit a power commander and you can remove the Lambda sensors all together (replacing with blanking plugs). Smooth's out the fueling a treat too.

 

[Bendy toy]

At the moment Ive got a fuel mixture problem. The bike runs rich on one side with the O2 sensors but fine with them disconnected. If I could be sure it wouldn't cook the valves I'd take the sensors off the bike. Maybe its time to call Hilltop.

 

[Ian]

Thanks for the advice. Have reconnected the sensors. All ok but although no air leaks I'm getting a bit of a back fire when shutting the throttle. No big deal.

Cheers guys.

 

[Bendy toy]

Pops on the overrun are normal. Roll the throttle not quite off and really goes off.