LED rear lights causing "bulb failure" light to stay on

[richb77]

Anyone know how to stop the LED rear lights making the "bulb out" warning lamp stay on?

I know i have to load the circuit to trick the sensor into thinking the correct current is being drawn, but with what and where does this thing go?

Cheers

 

[SMB]

The values that have worked are

Brake Light 10ohm 25W
Rear light 39ohm 50W

The 50W is OTT, but it is on all the time, however I reckon that a 20W would be fine but might get a little warm

see post 39
http://www.ukgser.com/forums/showthread.php?t=187526&page=3

Cheers

SMB

 

[Coolcarbon]

Anyone know how to stop the LED rear lights making the "bulb out" warning lamp stay on?

I know i have to load the circuit to trick the sensor into thinking the correct current is being drawn, but with what and where does this thing go?

Cheers

Before doing all that, try turning the ignition on without touching the brakes.

Allow the system to self check for the few seconds as usual and you should be left with just the ABS lights flashing before you move off as normal.

Once you set off they should all go out. Well, that works for me anyway...

Unless of course you've tried this already.....

 

[stolzy]

Before doing all that, try turning the ignition on without touching the brakes.

Allow the system to self check for the few seconds as usual and you should be left with just the ABS lights flashing before you move off as normal.

Once you set off they should all go out. Well, that works for me anyway...

Unless of course you've tried this already.....

Mine too - stays on until you move off then it goes out.